Lucas Type 4.7 mm Electrical Bullet Connector Pack- 22 Pieces

Description

LUCAS TYPE 4.7 mm ELECTRICAL BULLET CONNECTORS-
22 Piece Pack as shown in Picture
These Electrical Bullet Connectors are essential for restorers of
vintage British cars, trucks & motorcycles as well as
other European vehicles.
The Connectors are ideal
for use with 14 & 16 AWG Wire.
Quality British Made, but are not Lucas.
Male Hollow Tip
4.6 mm
Dia
Bullet Connectors:
6 Each
(Lucas Type #188156)
These Hollow Connectors are fitted by stripping a
Wire End about 5/16", and then placing the Connector below the wire, folding
the wire strands over.
The Male Bullet is 0
.
1 mm
smaller in diameter than a 4
.
7 mm Female Bullet
Connector.
The bent over wire strands at the Male
Bullet tip provide for a snug fit once inserted into a
Bullet Female Connector.
Male Solder
4.7 mm
Dia
Bullet Connectors:
10
Each
(Lucas Type #900269)
Solder Method:
(Connectors can also be Crimped to the Wire)
·
Strip Wire End about 5/16 inch & then using Sn60Pb40 Rosin Core Solder
, tin the Wire.
·
Secure tinned Wire End vertically.
·
Insert Bullet Connector onto the Stripped Wire end.
·
Apply heat to the Bullet Tip End while applying
solder.
·
Continue heating the Solder to the End '
just until'
the
Bullet Connector “Sinks” into the Wire
.  If needed, apply a small bead of solder to the connector opening.  Too much heat for an extended time will melt the wire insulation.
·
Once cooled, the Bullet Connector is dressed up using a Bench Grinder/Wire Wheel, or being Filed and/or Sanded.
Female Receptacle Single Sleeve
4.7 mm
Dia
Connectors:
4 Each
(Lucas Type #900288)
Connectors accept both type Male Bullet Connectors above.
They are used to join two Male Bullet Connectors together.
They are Rubber Outer Insulated, approximately 1 3/16” (30
.
15 mm) long.
Female Receptacle Double Sleeve
4.7 mm
Dia
Connectors:
2 Each
(Lucas Type  #850641)
Like the Female Single Sleeve, except accepts up to 4 Male
Bullet Connectors.
Shipping Weight; 3 oz (85
.
1 g)